英文字典中文字典


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       







请输入英文单字，中文词皆可：

inaudibility    

安装中文字典英文字典查询工具!


中文字典英文字典工具:
选择颜色:
输入中英文单字

































































英文字典中文字典相关资料:


  • Transmission kick down cable - shifting too harsh - Toyota Nation Forum
    They couldn't fix it but I found they had broken the cable at the base which caused the normal cable adjustment setting to be totally thrown off Another thing it could be is the pressure regulator valve is stuck in the valve body causing higher pressure than normal
  • How to tighten throttle cable | Toyota Tundra Forums
    Another option would be to replace the throttle cable, could be a pita though Sounds like a stretched cable You could also adjust the kickdown cable, I did that on my 4runner and I liked the result (better shifting) The kickdown cable connects from the throttle body to the transmission
  • Kickdown Cable Adjustment | IH8MUD. com Forum | Toyota . . . - IH8MUD Forum
    This is a post on "throttle" adjustment for the 1FZFE Two questions 1 is this the same as the "kickdown cable" adjustment and if so, 2 are the instructions the same for the '91-'92 3Fe?
  • automatic transmission: delayed, jerky shifts. throttle (kick-down . . .
    The 1st thing to do is step on the gas pedal and watch the kick-down cable Make sure it extends and retracts correctly If it's pulled out of the sheath and won't go back inside when the gas pedal is released, then your problem is definitely a bad kick-down cable
  • Auto transmission - Kickdown cable - Frazier
    To adjust cable proceed as follows: 1 Ensure that all slack is removed from the throttle cable side of the fuel pump linkage by adjusting the throttle cable There should only be a very small amount of freeplay at the throttle pedal 2 Disconnect the kick-down cable from the throttle arm 3
  • How to Replace a Car Kickdown Cable | YourMechanic Advice
    Step 13: Adjust the kickdown cable With the kickdown cable replaced, it is necessary to adjust it This is accomplished at the carburetor throttle body end of the cable, at the mounting bracket connector On the side of the kickdown cable’s outer case there is a button you will need to depress
  • How to Adjust Kick down Cable - Car Parts FAQ
    Follow the step-by-step instructions to adjust the tension of the kickdown cable accurately Properly align the throttle valve to ensure smooth shifting Determine the correct cable tension by referring to your vehicle’s specifications Make precise adjustments to achieve the desired tension
  • adusting kick down cable - Toyota Nation Forum
    There should be about 0 5 to 1mm space between the little metal collar and the rubber boot or sleeve for the throttle valve cable You can play around with that to tailor your shift point N E O
  • Kick Down Cable | IH8MUD. com Forum | Toyota, Lexus Off . . . - IH8MUD Forum
    Inspect the cable for any damage and replace if need be Depress the throttle cable fully and check the kickdown cable operates smoothly and extends fully You should see a rubber sleeve on the cable after the adjusting nuts where the cable goes thru the bracket at the throttle butterfly
  • Throttle Cable adjust - Toyota Nation Forum
    Check that the inner cable is NOT slack Measure the distance between the outer cable end and stopper on the cable Standard boot and cable stopper distance should be 0-0 04 inch 90-1mm) If the distance is not within specifications, adjust the cable using the adjusting nuts





中文字典-英文字典  2005-2009